10) Crank engine with fully charged battery, and read the highest
11) Carry out steps 8), 9) and 10) on each cylinder to obtain 4 read-
12) After checking, install spark plugs and ignition coils.
13) Connect ignition coil couplers.
14) Connect accelerator cable to clamp (For LH steering vehicle
1. Ignition coil
2. Spark plug
3. Accelerator cable
4. Clamp
pressure on compression gauge.
NOTE:
For measuring compression pressure, crank engine at
least 250 r/min. by using fully charged battery.
Standard
Limit
Max. difference between
any two cylinders
ings.
only).
ENGINE MECHANICAL (J20 ENGINE) 6A4-5
Compression pressure
1400 kPa
(14.0 kg/cm
1200 kPa
(12.0 kg/cm
100 kPa
(1.0 kg/cm
2
, 199.0 psi)
2
, 170.0 psi)
2
, 14.2 psi)