Suzuki 2000 Grand Vitara SQ625 Service Manual page 713

6H-20 CHARGING SYSTEM
1. Rear end cover
2. Insulator
1. IC regulator screws
2. IC regulator
3. "B" terminal inner nut
3. Brush holder screws
4. Brush holder assembly
1. Rectifier
1. Rubber insulator
1. Pulley
2. Hexagonal box
wrench
3. Offset wrench
1) Remove "B" terminal inner nut and insulator.
2) Remove rear end cover.
3) Remove 2 screws and pull out brush holder assembly.
4) Remove 3 screws and IC regulator.
5) Remove brush holder cover from brush holder.
6) Remove 4 screws, 1 bolt and rectifier.
7) Remove 4 rubber insulators (85 A type only).
8) Hold shaft by using hexagonal box wrench and remove pulley
nut, and then pull out pulley.
CAUTION:
_ To hold shaft, use hexagonal box. Duodecimal box may
cause slipping and consequential shaft or tool dam-
age.
_ Do not attempt to hold pulley by using vise or pipe
wrench so as not to distort it.