Radiator - Suzuki 2000 Grand Vitara SQ625 Service Manual

1. Cooling fan /
clutch nut

1. Radiator

2. Inlet hose (Outlet from oil cooler)
3. Outlet hose (Inlet to oil cooler)
INSTALLATION
Install removed parts in reverse order of removal procedure.
_ After installation, adjust belt tension for specification and tighten
each bolt and nut securely.
Tightening Torque
Cooling fan/dutch nut (G16 engine) (a):
.
11 N m (1.1 kg-m, 8.0 lb-ft)
Cooling fan/dutch nut (H25 and J20 engines) (a):
.
25 N m (2.5 kg-m, 18.0 lb-ft)
_ Refill cooling system with proper coolant referring to "COOLANT"
and steps 8) to 10) of "COOLING SYSTEM FLUSH AND REFILL"
in this section.
_ After installation, check each joint for leakage.
RADIATOR
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Drain cooling system by loosening drain plug (1) of radiator.
3) When servicing A/T vehicle, place oil pan under radiator (1) and
disconnect A/T fluid hoses (2), (3) from radiator.
4) Loosen cooling fan/clutch nuts (1).
5) Disconnect radiator inlet hose from radiator.
ENGINE COOLING 6B-17