INSTALLATION
1) Apply sealant to oil pan mating surface continuously as shown
in figure.
"A" Sealant: 99000-31150
2) Install oil pump strainer (1) and oil pan (3).
Install seal (2) in the position as shown in figure.
Tighten strainer bolt first and then bracket bolt to specified
torque.
Tightening Torque
.
(a): 11 N
m (1.1 kg-m, 8.0 lb-ft)
.
(b): 11 N
m (1.1 kg-m, 8.0 lb-ft)
After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts to specified torque.
Tightening Torque
.
(c): 11 N
m (1.1 kg-m, 8.0 lb-ft)
3) Install gasket and drain plug to oil pan (1).
Tighten drain plug to specified torque.
Tightening Torque
.
(a): 35 N
m (3.5 kg-m, 25.5 lb-ft)
4) Install clutch (torque converter) housing lower plate (1).
ENGINE MECHANICAL (G16 ENGINE) 6A1-25