"TOP"
1. Cylinder head gasket
4. Crankshaft pulley side
2. Cylinder block
5. Flywheel side
3. Knock pin
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
3. Bolt (M6)
9) Install intake manifold, injectors, exhaust manifold, water outlet
pipe and water outlet cap to cylinder head.
NOTE:
When installing water outlet pipe, apply sealant to the
thread of the bolt shown in figure.
"A": Sealant 99000-31110
1. Cylinder head
2. Water outlet pipe
INSTALLATION
1) Clean mating surface of cylinder head and cylinder block.
Remove oil, old gasket and dust from mating surface.
2) Install knock pins to cylinder block.
3) Install new cylinder head gasket to cylinder block.
"TOP" mark provided on gasket comes to crankshaft pulley side,
facing up (toward cylinder head side).
4) Install cylinder head to cylinder block.
Apply engine oil to cylinder head bolts and tighten them gradual-
ly as follows.
(1) Tighten all bolts to 53 N
(2) In the same manner as in (1), tighten them to 84 N
(3) Loosen all bolts until tightening torque is reduced to 0 in the
(4) Tighten all bolts to 53 N
(5) In the same manner as in (4) again, tighten them to specified
ENGINE MECHANICAL (J20 ENGINE) 6A4-55
numerical order in figure.
kg-m, 61.0 lb-ft).
illustrated order.
numerical order in figure.
torque.
Tightening Torque
.
(a): 105 N
m (10.5 kg-m, 76.0 lb-ft)
.
(b): 11 N
m ( 1.1 kg-m, 8.0 lb-ft)
NOTE:
Be sure to tighten M6 bolt after securing the other bolt.
.
m (5.3 kg-m, 38.5 lb-ft) according to
.
m (5.3 kg-m, 38.5 lb-ft) according to
.
m (8.4