Suzuki 2000 Grand Vitara SQ625 Service Manual page 373

1. Oil pump drive chain
2. Oil pump sprocket
3. Match mark
1. Oil pump chain guide
2) Install oil pump chain by aligning match marks on oil pump
3) Install oil pump chain guide and hand-tighten oil pump chain
1, (c)
4) To take up slack of oil pump chain, push center of oil pump
(c)
5) Install 1st timing chain.
6) Install LH bank 2nd timing chain.
7) Install timing chain cover.
8) Install oil pan, front differential housing, P/S system, cooling
9) Refill cooling system with coolant, front differential with gear oil,
10) Check wheel alignment referring to Section 3.
11) Verify that there is no fuel leakage, water leakage and oil leak-
chain and oil pump sprocket.
guide bolts.
chain guide with a force of 0.5 to 0.6 N (50 – 60 g, 0.11 – 0.13
lb) then tighten oil pump chain guide bolts to specified torque.
Tightening Torque
.
(c): 11 N m (1.1 kg-m, 7.5 lb-ft)
Refer to item "1ST TIMING CHAIN AND CHAIN TENSIONER"
in this section for installation.
Refer to item "LH (NO.1) BANK 2ND TIMING CHAIN AND
CHAIN TENSIONER" in this section for installation.
Refer to item "TIMING CHAIN COVER" in this section for instal-
lation.
system, intake manifold with throttle body and other parts.
P/S system with specified fluid and engine with engine oil.
age at each connection.
ENGINE MECHANICAL (H25 ENGINE) 6A2-49