Suzuki 2000 Grand Vitara SQ625 Service Manual page 690

6G1-10 CRANKING SYSTEM
Drive
4. BRUSH HOLDER
Check movement of brush in brush holder. If brush movement
within brush holder is sluggish, check brush holder for distortion
and sliding faces for correct contamination.
Clean or correct as necessary.
Clean for continuity across insulated brush holder (positive side)
and grounded brush holder (negative side).
If continuity exists, brush holder is grounded due to defective in-
sulation and should be replaced.
5. SPRING
Inspect brush spring for wear, damage or other abnormal condi-
tions. Replace if necessary.
Brush spring tension
6. DRIVE LEVER
Inspect drive lever for wear. Replace if necessary.
7. PINION AND OVER-RUNNING CLUTCH
D Inspect pinion for wear, damage or other abnormal conditions.
Check that clutch locks up when turned in direction of drive
and rotates smoothly in reverse direction. Replace if neces-
sary.
Reverse
Standard: 1.95 kg (4.3 lb)
Limit: 0.9 kg (1.98 lb)