Suzuki 2000 Grand Vitara SQ625 Service Manual page 275

1. CMP sensor
2. CMP sensor case
1. Valve adjusting screw
2. Lock nut
3. Rocker arm
1. Oil plug
2. Timing belt
inside cover
5) Remove camshaft timing belt pulley by using special tool.
6) Remove cylinder head cover as previously outlined.
1. Camshaft pulley
7) Disconnect CMP sensor connector and remove CMP sensor
8) After loosening all valve adjusting screw lock nuts, turn adjust-
9) Remove camshaft housing and camshaft.
10) Remove rocker arm shaft plug and timing belt inside cover.
Special Tool
(A): 09917-68220
case from cylinder head.
Place a container or rag under CMP sensor case, for a small
amount of oil flows out during removal of case.
ing screws back all the way to allow all rocker arms to move
freely.
NOTE:
To remove camshaft housing bolts, loosen them in such
order as indicated in figure, a little at a time.
ENGINE MECHANICAL (G16 ENGINE) 6A1-33