Crankshaft Position Sensor - Suzuki 2000 Grand Vitara SQ625 Service Manual

6E1-40 ENGINE AND EMISSION CONTROL SYSTEM (G16 / J20 ENGINES)
(a)

1. Crankshaft position sensor

2. Cylinder block
CRANKSHAFT POSITION SENSOR (G16 Engine)
Inspection
Check crankshaft position sensor referring to Steps 2 and 3 of DTC
P0335 Diag. Flow Table in "Engine Diagnosis" section. If malfunc-
tion is found, replace.
Removal
1) Hoist vehicle.
2) Disconnect connector from crankshaft position sensor.
3) Remove crankshaft position sensor from oil pan.
Installation
1) Check to make sure that crankshaft position sensor and pulley
tooth is free from any metal particles and damage.
2) Install crankshaft position sensor to oil pan.
Tightening Torque
.
(a): 10 N m (1.0 kg-m, 7.5 lb-ft)
CAUTION:
Be sure to tighten to specified torque. CKP sensor will be
deformed if overtightened and correct CKP sensor signal
will not be fed if loosened.
3) Connect connector to it securely.
CRANKSHAFT POSITION SENSOR (J20 Engine)
Inspection
Check crankshaft position sensor referring to Steps 2 and 3 of DTC
P0335 Diag. Flow Table in "Engine Diagnosis" section. If malfunc-
tion is found, replace.
Removal
1) Remove transmission from vehicle and then remove flywheel or
drive plate from crankshaft.
2) Disconnect connector from crankshaft position sensor.
3) Remove crankshaft position sensor from cylinder block.
Installation
Reverse removal procedure noting the following.
D Check to make sure that crankshaft position sensor is free from
any metal particles and damage.
D Apply engine oil to O-ring of sensor.
D Install crankshaft position sensor to cylinder block.
Tightening Torque
.
(a): 6 N m (0.6 kg-m, 4.5 lb-ft)
D Connect connector and fix wire harness with clamp securely.