Suzuki 2000 Grand Vitara SQ625 Service Manual page 347

1. Timing chain cover
2. Oil seal
4
1. Crankshaft pulley
2. Bolt
3. Wrench
4. CKP sensor
CLEAN
Clean sealing surface on timing chain cover, crankcase, cylinder
block and cylinder heads.
Remove oil, old sealant, and dust from sealing surface.
INSPECTION
Check oil seal lip for damages or deterioration.
Replace as necessary.
NOTE:
When installing new oil seal, top it in until its surface is flash
with edge of timing chain cover.
To install oil seal, use special tool (bearing installer).
Special Tool
(D): 09913-75510
INSTALLATION
Reverse removal sequence to install timing chain cover noting fol-
lowing points.
1) Apply sealant "A" to timing chain cover sealing surface area as
2) Apply engine oil to oil seal lip and water pump O-ring, then install
1. Timing chain cover
2. Sealant "A"
(d): All bolts
3) Apply engine oil to O-ring of CKP sensor and install CKP sensor
4) Install crankshaft pulley.
shown in figure.
"A": Sealant 99000-31150
timing chain cover.
Tightening Torque
.
(d): 11.0 N m (1.1 kg-m, 7.5 lb-ft)
to timing chain cover.
Tightening torque
.
(b): 6 N m (0.6 kg-m, 4.5 lb-ft)
To lock crankshaft pulley, use special tool (camshaft pulley hold-
er) with it at shown in figure.
Special Tool
(A): 09917-68221
CAUTION:
Be sure to use the following bolt for fixing special tool to
crank pulley.
Bolt size: M8, P1.25 = 45 mm
Strength: 7T
Tightening Torque
.
(a): 150 N m (15 kg-m, 108.5 lb-ft)
ENGINE MECHANICAL (H25 ENGINE) 6A2-23