Suzuki 2000 Grand Vitara SQ625 Service Manual page 339

1. Stiffener
2. Exhaust No.1 pipe
1. Exhaust manifold stiffener
2. Exhaust No.1 pipe
3. Transmission
1. Left (No.1) exhaust manifold
2. Right (No.2) exhaust manifold
7) Hoist vehicle.
8) For 4WD vehicle, before disconnecting front propeller shaft,
put match mark on joint flange and propeller shaft to facilitate
their installation as shown in figure.
9) For 4WD vehicle, disconnect propeller shaft from front differen-
tial.
1. Match mark
10) Remove exhaust No.1 pipe.
11) Detach exhaust manifold stiffener from transmission case.
12) Remove exhaust manifolds and their gaskets from cylinder
heads.
INSTALLATION
1) Install new manifold gaskets to cylinder heads and No.1 pipe
gasket to exhaust No.1 pipe.
2) Install exhaust manifolds.
D Always install new bolts with pre-coated adhesive to the loca-
tions with L mark.
D Tighten both manifold nuts and bolts to specified torque.
Tightening Torque
(a): 30 N
3) Attach exhaust manifold stiffener to transmission.
ENGINE MECHANICAL (H25 ENGINE) 6A2-15
.
m (3.0 kg-m, 21.5 lb-ft)