Suzuki 2000 Grand Vitara SQ625 Service Manual page 503

6A4-84 ENGINE MECHANICAL (J20 ENGINE)
1. Engine side mounting bracket
2. Water pump
3. Heater outlet pipe
1. Oil pump chain guide
2. Oil pump chain guide nuts
3. Thickness gauge
9) Install engine side mounting brackets (right and left).
Tighten bracket bolts to specified torque.
Tightening Torque
(d)
(d): 50 N
10) Install water pump and heater outlet pipe.
Refer to Section 6B.
11) Install pistons and connecting rods as previously outlined.
12) Install oil pump. Refer to "Oil pump" in this section.
13) In case of oil pump chain guide is reinstalled or new oil pump
chain is installed, if chain guide hole is oval type, adjust clear-
ance between oil pump chain and oil pump chain guide as fol-
lows:
i) Install oil pump chain guide and nuts temporarily.
ii) To take up slack of oil pump chain, insert 0.5 mm (0.020 in.)
thickness gauge between chain guide and chain and pull
chain guide in arrow direction with a force of 20 to 30 N
(2 – 3 kg, 4.4 – 6.6 lb).
iii) With pulling chain guide in step ii), tighten oil pump chain
guide nuts and pull out thickness gauge.
14) Install cylinder head assembly to cylinder block as previously
outlined.
15) Install timing chains, timing chain tensioner, timing chain guide,
timing chain sprockets, timing chain cover, crankshaft pulley,
water pump pulley, etc., as previously outlined.
16) Install oil pump strainer and oil pan.
17) Install clutch to flywheel (for M/T vehicle). For clutch installa-
tion, refer to Section 7C1.
18) Install engine assembly to vehicle as previously outlined.
.
m (5.0 kg-m, 36.5 lb-ft)