1. Exhaust No.1 pipe
1. Exhaust manifold stiffener
1. Crankshaft pulley side
2. Flywheel side
3. Bolt (M6)
13) Disconnect exhaust No. 1 pipe from exhaust manifold.
14) Remove exhaust manifold stiffener (if equipped).
15) Loosen cylinder head bolts in such order as indicated in figure
and remove them.
NOTE:
Don't forget to remove bolt (M6) shown in figure.
16) Check all around cylinder head for any other parts required to
be removed or disconnected and remove or disconnect what-
ever necessary.
17) Remove cylinder head with intake manifold, exhaust manifold
and water outlet pipe. Use lifting device if necessary.
ENGINE MECHANICAL (J20 ENGINE) 6A4-47