Engine Diagnosis; General Description; On-Board Diagnostic System (Vehicle Without Monitor Connector) - Suzuki 2000 Grand Vitara SQ625 Service Manual

GENERAL DESCRIPTION

This vehicle is equipped with an engine and emission control system which are under control of ECM (PCM).
The engine and emission control system in this vehicle are controlled by ECM (PCM). ECM (PCM) has an On-
Board Diagnostic system which detects a malfunction in this system and abnormality of those parts that influence
the engine exhaust emission. When diagnosing engine troubles, be sure to have full understanding of the outline
of "ON-BOARD DIAGNOSTIC SYSTEM" and each item in "PRECAUTION IN DIAGNOSING TROUBLE" and
execute diagnosis according to "ENGINE DIAGNOSTIC FLOW TABLE" in this section.
There is a close relationship between the engine mechanical, engine cooling system, ignition system, exhaust
system, etc. and the engine and emission control system in their structure and operation. In case of an engine
trouble, even when the malfunction indicator lamp (MIL) doesn't turn ON, it should be diagnosed according to "EN-
GINE DIAGNOSTIC FLOW TABLE" in this section.
or
2

ENGINE DIAGNOSIS

ON-BOARD DIAGNOSTIC SYSTEM
(VEHICLE WITHOUT MONITOR CONNECTOR)
ECM (PCM) in this vehicle has following functions.
D When the ignition switch is turned ON with the engine at a stop,
MIL (1) turns ON to check the bulb of the malfunction indicator
lamp (MIL).
D When ECM (PCM) detects a malfunction which gives an adverse
effect to vehicle emission while the engine is running, it makes the
malfunction indicator lamp in the meter cluster of the instrument
1
panel turn ON or flash (flashing only when detecting a misfire
which can cause damage to the catalyst) and stores the malfunc-
tion area in its memory.
(If it detects that continuously 3 driving cycles are normal after de-
tecting a malfunction, however, it makes MIL turn OFF although
DTC stored in its memory will remain.)
D As a condition for detecting a malfunction in some areas in the
system being monitored by ECM (PCM) and turning ON the mal-
function indicator lamp due to that malfunction, 2 driving cycle
detection logic is adopted to prevent erroneous detection.
D When a malfunction is detected, engine and driving conditions
then are stored in ECM (PCM) memory as freeze frame data. (For
the details, refer to description on Freeze frame data.)
D It is possible to communicate by using not only SUZUKI scan tool
(Tech-1) (2) but also generic scan tool. (Diagnostic information
can be accessed by using a scan tool.)
ENGINE (H25 ENGINE) 6-1-9