On-Vehicle Service; High-Tension Cord - Suzuki 2000 Grand Vitara SQ625 Service Manual

6F1-8 IGNITION SYSTEM (FOR G16 ENGINE)

ON-VEHICLE SERVICE

HIGH-TENSION CORD

REMOVAL
1) Remove high-tension cord from ignition coil assembly while
2) Pull out high-tension cord from spark plug while gripping its cap.
1. Ignition coil assembly
2. High-tension cord
INSPECTION
Measure resistance of high-tension cord by using ohmmeter.
High-tension cord resistance: 4 – 10 kW/m (1.2 – 3.0 kW/ft)
Check for damage, deterioration and terminal corrosion.
If check result is not satisfactory, replace high-tension cord(s).
INSTALLATION
1) Install high-tension cord to spark plug and ignition coil assembly
1. Ignition coil assembly
2. High-tension cord
gripping its cap.
CAUTION:
_ Removal of high-tension cords together with clamps
will be recommended so as to damage their inside wire
(resistive conductor).
_ For the same reason, pull out each connection by grip-
ping cap portion.
while gripping its cap.
CAUTION:
_ Never attempt to use metal conductor high-tension
cord(s) as replacing parts.
_ Insert each cap potion fully when installing high-ten-
sion cords.