1. Rear end frame
3. Rear end frame nut
2. Rotor shaft
1. End housing bearing
2. Bearing puller
3. Bearing cover
1. Stud bolt
3. Drive end bearing
2. Retaining plate
4. Stator
9) Remove 4 rear end frame nuts.
10) Drive out rear end frame with rotor tapping shaft lightly by using
plastic hammer.
11) Separate rear end frame from rotor evenly by using plastic
hammer.
CAUTION:
Do not hit shaft at slip ring side, when separating rotor
and rear end frame.
12) If required, use bearing puller to remove end housing bearing
and bearing cover.
CAUTION:
Care must be exercised so as not to distort cooling fan
blade while applying puller.
13) If required, remove 4 screws, retainer plate and then drive out
drive end bearing.
14) If required, remove stud bolts and then pull out stator.
NOTE:
Heating drive end frame may facilitate removal of stator.
CHARGING SYSTEM 6H-21