Suzuki 2000 Grand Vitara SQ625 Service Manual page 392

6A2-68 ENGINE MECHANICAL (H25 ENGINE)
8) Install valve lash adjuster, camshaft, CMP sensor and RH bank
2nd timing chain.
Refer to item "CAMSHAFT AND VALVE LASH ADJUSTER"
and "RH (NO.2) BANK 2ND TIMING CHAIN AND CHAIN TEN-
SIONER" in this section. For CMP sensor, refer to Section 6F2
for installation.
9) Install 1st timing chain.
Refer to item "1ST TIMING CHAIN AND CHAIN TENSIONER"
in this section for installation.
10) Install LH bank 2nd timing chain.
Refer to item "LH (NO.1) BANK 2ND TIMING CHAIN AND
CHAIN TENSIONER" in this section for installation.
11) Install timing chain cover.
Refer to item "TIMING CHAIN COVER" in this section for instal-
lation.
12) Install oil pan and oil pump strainer.
Refer to item "OIL PAN AND OIL PUMP STRAINER" in this
section for installation.
13) Install cylinder head cover.
Refer to item "CYLINDER HEAD COVER" in this section for
installation.
14) Install exhaust manifold.
Refer to item "EXHAUST MANIFOLD" in this section for instal-
lation.
15) Install radiator outlet pipe radiator, cooling fan and water hose.
Refer to Section 6B installation.
16) Install throttle body and intake manifold.
Refer to item "THROTTLE BODY AND INTAKE MANIFOLD"
in this section for installation.
17) Adjust water pump drive belt tension.
Refer to Section 6B for adjusting procedure.
18) Adjust power steering pump drive belt tension.
Refer to Section 3B1 for adjusting procedure.
19) Adjust accelerator cable play and A/T throttle cable play. Refer
to Section 6E2.
20) Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
21) Refill engine with engine oil, referring to item "ENGINE OIL
CHANGE" in Section 0B.
22) Refill cooling system referring to Section 6B.
23) Refill front differential housing with gear oil if drained, referring
to "DIFFERENTIAL" section.
24) Connect negative cable at battery.
25) Check ignition timing and adjust as necessary, referring to Sec-
tion 6F2.
26) Verify that there is no fuel leakage, water leakage, oil leakage
and exhaust gas leakage at each connection.
27) Check wheel alignment, referring to Section 3.