Suzuki 2000 Grand Vitara SQ625 Service Manual page 406

6A2-82 ENGINE MECHANICAL (H25 ENGINE)
1. Engine side mount bracket
1. Bolt (Short)
2. Bolt (Long)
(c)
32) Install lifting device.
33) Disconnect engine side mounting brackets to engine mount-
34) Before lifting engine, check to ensure all hoses, wires and
35) Remove engine assembly from chassis and transmission by
INSTALLATION
Reverse removal procedure for installation, noting following points.
1) Lower engine assembly into engine compartment. Connect en-
gine to transmission and engine side mounting brackets to en-
gine mountings.
2) Tighten nuts fastening engine side mounting brackets and en-
gine mountings.
Tightening Torque
(a): 50 N
3) Tighten bolts and nuts fastening cylinder block and transmission
to specified torque.
1, (b)
Tightening Torque
(b): 85 N
4) Remove lifting device
2, (b)
(b)
1, (b)
2, (b)
5) Tighten torque converter bolts to specified torque (for A/T ve-
hicle).
Tightening Torque
(c): 65 N
ings.
cables are disconnected from engine.
sliding toward front, and then, carefully hoist engine assembly.
.
m (5.0 kg-m, 36.5 lb-ft)
.
m (8.5 kg-m, 61.5 lb-ft)
.
m (6.5 kg-m, 47.0 lb-ft)