Suzuki 2000 Grand Vitara SQ625 Service Manual page 139

6-1-28 ENGINE (H25 ENGINE)
SCAN TOOL DATA
THROTTLE POS
(Absolute Throttle Position) (Absolute Throttle Position)
TP SENSOR VOLT
(TP Sensor Out ut Voltage) (TP Sensor Output Voltage)
OXYGEN SENSOR B1 S1
(HO2S1 Output Voltage)
OXYGEN SENSOR B1 S2
(HO2S2 Output Voltage)
OXYGEN SENSOR B2 S1
(HO2S2 Output Voltage)
OXYGEN SENSOR B2 S2
(HO2S2 Output Voltage)
FUEL SYSTEM B1
(Fuel System Status)
FUEL SYSTEM B2
(Fuel System Status)
CALC LOAD
(Calculated Load Value)
TOTAL FUEL TRIM B1
TOTAL FUEL TRIM B2
MAP
CANIST PRG DUTY
(EVAP Canister Purge Flow
Duty)
Vehicle Speed
FUEL CUT
EGR VALVE
PSP SWITCH
(if equipped)
A / C SWITCH
(if equipped)
PNP SIGNAL (Transmission
Range Switch) A / T only
FUEL TANK LEVEL
CONDITION
Ignition switch Accelerator pedal released.
ON / warmed up ON / warmed u
Accelerator pedal depressed fully.
engine stopped.
Ignition switch Accelerator pedal released.
ON / warmed up ON / warmed u
Accelerator pedal depressed fully.
engine stopped.
At specified idle speed after warming up.
When engine is running at 2000 r / min. for 3 min or longer
after warming up.
When engine is running at 2000 r / min. for 3 min or longer
after warming up.
When engine is running at 2000 r / min. for 3 min or longer
after warming up.
At specified idle speed after warming up.
At specified idle speed after warming up.
At specified idle speed with no load after warming up.
At 2500 r / min with no load after warming up.
At specified idle speed after warming up.
At specified idle speed after warming up.
At specified idle speed after warming up.
At specified idle speed after warming up.
At stop.
When engine is at fuel cut condition.
Other than fuel cut condition.
At specified idle speed after warming up.
Engine running at idle speed and steering wheel at
straightahead position.
Engine running at idle speed and steering wheel
turned to the right or left as far as it stops.
When A / C not operating.
When A / C operating.
Ignition switch Selector lever in "P" or "N" position
ON
Selector lever in "R", "D", "2" or "L"
position
Ignition switch ON
NORMAL CONDITION /
REFERENCE VALUE
10 + 5 %
80 + 10 %
0.35 X 0.65 V
3.0 X 3.8 V
0.05 X 0.95 V
0.05 X 0.95 V
0.05 X 0.95 V
0.05 X 0.95 V
Closed
Closed
1.8 X 3.8 %
6.0 X 11.5 %
–30 X +30 %
– 30 X +30 %
25 X 35 kPa
0 X 10 %
0 km / h 0MPH
ON
OFF
0 %
OFF
ON
OFF
ON
P / N Range
D Range
0 X 100 %
OTHER
: :
:
:
:
: :
:
: :
: :
:
: