1. Lower crankcase
2. Bolt (10 mm thread diameter)
3. Bolt (8 mm thread diameter)
1. Rear oil seal
(a)
1, (c), "A"
6)
7)
1. Flywheel bolt
7-1) Install crankshaft position sensor and fix its wire harness with
1. CKP sensor
2. Cylinder block
3. Crankshaft
8)
(A)
ENGINE MECHANICAL (J20 ENGINE) 6A4-83
Install lower crankcase to cylinder block. Apply oil to crank-
case bolts before installing them. Tighten crankcase bolts to
70% torque of specified torque, following sequence in figure
and then tighten crankcase bolts to specified torque accord-
ing to numerical order in figure.
Tightening Torque
.
(a): 60 N
m (6.0 kg-m, 43.5 lb-ft)
.
(b): 27 N
m (2.7 kg-m, 19.5 lb-ft)
NOTE:
After tightening crankcase bolts, check to be sure that
crankshaft rotates smoothly when turned by hand.
Install rear oil seal by using plastic hammer and special tools.
Special Tool
(A): 09911-97710
(B): 09911-97810
bracket.
Tightening Torque
.
(a): 6 N
m (0.6 kg-m, 4.5 lb-ft)
Install flywheel (M/T vehicle) or drive plate (A/T vehicle).
Using special tool, lock flywheel or drive plate, and tighten
flywheel or drive plate bolts applied with sealant to specifica-
tion.
"A": Sealant 1215 99000-31110
Special Tool
(A): 09924-17810
Tightening Torque
.
(c): 70 N
m (7.0 kg-m, 51.0 lb-ft)