Suzuki 2000 Grand Vitara SQ625 Service Manual page 532

FUEL PUMP
REMOVAL
1) Remove fuel tank. Refer to "FUEL TANK" in this section.
2) Remove fuel pump assembly from fuel tank.
INSPECTION
Check fuel pump filter for evidence of dirt and contamination.
If present, clean and check for presence of dirt in fuel tank.
INSTALLATION
Reverse removal procedure for installation noting the followings.
D Use new gasket.
D Tighten fuel pump bolts to specified torque.
1. Fuel pump assembly
2. Gasket
3. To fuel filter
4. From delivery pipe
FUEL FILTER
REMOVAL
1) Relieve fuel pressure in fuel feed line referring to SECTION 6 or
2) Disconnect negative (–) cable at battery.
3) Hoist vehicle.
4) Disconnect inlet and outlet hoses (2), (3) from fuel filter (1).
5) Remove fuel filter (1) from chassis frame.
Tightening Torque
Fuel pump bolt (a): 5.0 N
SECTION 6-1.
CAUTION:
This work must not be done when engine is hot. If done
so, it may cause adverse effect to catalyst.
WARNING:
A small amount of fuel may be released after fuel line is
disconnected. In order to reduce the chance of personal
injury, cover the fitting to be disconnected with a shop
cloth. Be sure to put that cloth in an approved container
when disconnection is completed.
ENGINE FUEL 6C-3
.
m (0.5 kg-m, 3.5 lb-ft)