6A4-56 ENGINE MECHANICAL (J20 ENGINE)
1. Timing mark
2. Crank timing sprocket key
5) Check that key on crankshaft aligns with timing mark as shown
in figure.
6) Reverse removal procedure for installation.
7) Adjust cooling fan belt tension.
Refer to Section 6B for adjusting procedure.
8) Adjust accelerator cable play and A/T throttle cable play (for
vehicle with A/T). Refer to Section 6E1.
9) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been reinstalled.
10) Refill engine with engine oil, referring to item "ENGINE OIL
CHANGE" in Section 0B.
11) Refill cooling system referring to Section 6B.
12) Refill front differential housing with gear oil, referring to "DIF-
FERENTIAL" section.
13) Refill power steering system with specified fluid referring to
Section 3B1.
14) Connect negative cable at battery.
15) Verify that there is no fuel leakage, coolant leakage, oil leakage
and exhaust gas leakage at each connection.
16) Check ignition timing and adjust as necessary, referring to Sec-
tion 6F2.