Suzuki 2000 Grand Vitara SQ625 Service Manual page 444

1. Generator belt
idler pulley
2. A / C compressor
bracket
3. Radiator outlet hose
1. Water bypass pipe 3. Water pump pulley
2. Water bypass hose 4. Generator belt
No.2 tensioner
4) Install A/C compressor bracket if equipped.
Tighten bracket bolts to specified torque.
Tightening Torque
.
(a): 55 N m (5.5 kg-m, 40.0 lb-ft)
5) Install generator belt idler pulley.
Tighten nut to specified torque.
Tightening Torque
.
(b): 45 N m (4.5 kg-m, 33.0 lb-ft)
6) Connect radiator outlet hose to thermostat cap.
7) Install generator belt tensioner.
Tighten bolts to specified torque.
Tightening Torque
.
(a): 25 N m (2.5 kg-m, 18.5 lb-ft)
8) Install water pump pulley.
9) Install generator belt by turning generator belt tensioner center
bolt clockwise to loosen tension of generator belt.
10) Install cooling fan belt, fan pulley, cooling fan and shroud.
11) Install bypass pipe and water bypass hose No.2.
12) Install cylinder head cover.
Refer to item "CYLINDER HEAD COVER" in this section for
installation.
13) Install oil pan and oil pump strainer.
Refer to item "OIL PAN AND OIL PUMP STRAINER" in this
section for installation.
14) Adjust cooling fan belt tension.
Refer to Section 6B for adjusting procedure.
15) Refill cooling system with coolant, front differential with gear oil,
engine with engine oil and power steering system with speci-
fied fluid.
16) Verify that there is no coolant leakage, oil leakage, power
steering fluid leakage and exhaust gas leakage at each con-
nection.
ENGINE MECHANICAL (J20 ENGINE) 6A4-25