Motorola DSP96002 User Manual page 330

FMPY//FADDSUB.S
Floating-Point Multiply, Add, and Subtract
Operation:
S1 * S2 ROUND(MP)
(parallel data bus move)
D3 + D2 ROUND(SP)
D3 - D2 ROUND(SP)
Description:
Multiply the two operands S1 and S2, round to the precision indicated by the MP mode bit and store the
result in the specified destination register D1. Simultaneously, add the two operands D2 and D3, subtract
D2 from D3, round both results to single precision and store the result of the addition in register D2 and
of the subtraction in register D3. Typically, if the result of the multiplication will be used immediately follow-
ing a data ALU instruction such as FADD (i.e., equivalent to an FMAC), the maximum precision (MP=1) will
be programmed. However, if the product is to be stored, then single precision (MP=0) rounding will be used.
For the special case of |s|=|D|, the result can be +0 or -0; the sign of the resulting zero will be the sign of
the input operand in D.
Input Operand(s) Precision: SEP Floating-Point.
Addition Output Operand Precision: SP Floating-Point.
Subtraction Output Operand Precision: SP Floating-Point.
Multiplication Output Operand Precision: as indicated by MP.
CCR Condition Codes:
C
V
Z
N
I
LR
–
R
A
A - 142
D1
D2
D3
- Not affected.
- Not affected.
- Set if result of the addition is zero. Cleared otherwise.
- Set if result of the addition is negative. Cleared otherwise.
- Set if result of the addition is infinity. Cleared otherwise.
- Not affected.
- Not affected.
- Not affected.
DSP96002 USER'S MANUAL
FMPY//FADDSUB.S
Assembler Syntax:
FMPY S1,S2,D1 FADDSUB.S D3,D2
(move syntax - see the MOVE instruction descrip-
tion.)
FMPY S2,S1,D1 FADDSUB.S D3,D2
(move syntax - see the MOVE instruction descrip-
tion.)
MOTOROLA