Table of Contents
Advertisement
10.2.3 Debug Serial Output (DSO)
The debug serial output provides the data contained in one of the OnCE
by the last command received from the external command controller. When idle, this pin is held high. When
the requested data is available, the DSO line will be asserted (negative true logic) for two T cycles (2T =
period of DSP96002 master clock) to indicate that the serial shift registers are ready to receive clocks in
order to deliver the data. When a trace or breakpoint occurs this line will be asserted for one T cycle to
indicate (acknowledge) that the chip has entered the debug mode and is waiting for commands. Data is
always shifted out the OnCE
held high.
10.2.4 Debug Enable Input (
The debug request input provides a means of entering the debug mode of operation from the external com-
mand controller. This pin, when asserted, causes the DSP96002 to finish the current instruction being exe-
cuted, save the instruction pipeline information, enter the debug mode, and wait for commands to be en-
tered from the debug serial input line.
10.3 OnCE
CONTROLLER AND SERIAL INTERFACE
The OnCE
Controller and Serial Interface contains the following blocks: input shift register, bit counter,
OnCE
decoder, and the status/control register. Figure 10-2 illustrates a block diagram of the OnCE se-
rial interface.
10.3.1
OnCE
Input Shift Register (OISR)
The OnCE Input Shift Register is an 8-bit shift register that receives the serial data from the DSI line. The
data is clocked into the register on the falling edge of the clock applied to the DSCK pin. After the 8th bit is
received, the OISR will stop shifting in new data. The latched data will be used as input for the OnCE De-
coder. The data is always shifted into the OISR most significant bit (MSB) first.
10.3.2 OnCE
Bit Counter (OBC)
The OnCE
Bit Counter is a 5-bit counter associated with shifting in and out the data bits. The OBC is in-
cremented by the falling edges of the DSCK. The OBC is cleared during hardware reset and whenever the
DSP96002 acknowledges that the Debug Mode has been entered. The OBC supplies two signals to the
OnCE
Decoder: one indicating that the first 8 bits were shifted-in (so a new command is available) and
the second indicating that 32 bits were shifted-in (the data associated with that command is available) or
that 32 bits were shifted-out (the data required by a read command was shifted out).
10.3.3 OnCE
Decoder (ODEC)
The OnCE Decoder supervises the entire OnCE activity. It receives as input the 8-bit command from the
OISR, two signals from OBC (one indicating that 8 bits have been received and the other that 32 bits have
MOTOROLA
serial port most significant bit (MSB) first. During hardware reset, this pin is
—
–
D
R)
DSP96002 USER'S MANUAL
controller registers as specified
10 - 3
Advertisement
Table of Contents
