Xerox DocuColor 12/DCCS50 Service Manual page 1396

Figure 19 Remove the Caster Wrench
The underside of the HCF has very sharp edges! Use caution when adjusting.
NOTE: To adjust the casters, raise the HCF by turning the caster nut CCW. Turn the caster nut
CW to lower the HCF. For best results, alternate between casters. The two INSIDE casters
(near the processor) are off the floor when installed, and do not require adjustment.
20. If the gap is not wide enough or is not uniform, adjust the two outside casters
Installation Instructions
WARNING 21. 1. Place the HCF wrench back onto the rails
2. Push the HCF against the processor.
(Figure 20).
1/05
9-22
manuals4you.com manuals4you.com
Figure 20 Adjust the Casters
(Figure 21).
DocuColor 12/DCCS50
Reissue