Xerox DocuColor 12/DCCS50 Service Manual page 1595

Finisher Transport Motor
The Finisher Transport Motor is located in the Compiler section of the Finisher. The Finisher
PWB sends power to the Transport Motor, which uses gears and pulleys to drive the Stapler
Entry/Exit, and the paper Exit functions (Figure
used to switch the Transport Motor on, and to control its speed. The Transport Motor is pow-
ered by +24 VDC.
Figure 1 Finisher Transport Assembly
Finisher Transport Mechanical Drive Components
1. Finisher Transport Motor
A +24 VDC stepper motor. Provides drive for the Transport.
2. Transport Gears
Transmits Motor drive to Pulley.
3. Compiler Transport Drive Belt
Transmits Finisher Transport Motor drive to the Eject Shaft, Exit Shaft, and the Paddle
Shaft.
Reissue
DocuColor 12/DCCS50
1). +5 VDC voltages from the Finisher PWB are
Eject Motor
The Finisher PWB switches the Eject Motor clockwise to Eject paper into the Stacker. The Fin-
isher PWB switches the Eject Motor counter clockwise to drive the paper back into the Com-
piler Tray. The Eject Motor Drive Belt transmits drive from the Motor to Eject Gear B. Gear B
drives Eject Shaft 2. Eject Shaft 1 is driven by the Eject Paddle Motor, while the Eject Rolls on
Eject Shaft 1 are independently driven by gearing from Eject Shaft 2
1/05
Finisher Transport Motor, Eject Motor
10-175
(Figure 1, Figure 2).
Principles of Operation