Finisher Paper Path For Stapling And Stacking - Xerox DocuColor 12/DCCS50 Service Manual

Drives paper to the Eject Roll.
4. Eject Roll and Paddle Assembly
Drives paper into a Finisher Bin Tray.
The Eject Roll assembly is shifted from side-to-side so that each set entering the Finisher Bin
Tray is offset slightly from the previous set.
For additional information, see Eject Paddle Motor
Principles of Operation
Finisher Path for Stacking without Stapling, Finisher

Finisher Paper Path for Stapling and Stacking

The following explanation assumes the following:
1. The job is a print job.
2. Stapling was requested.
3. The paper has been decurled.
4. The paper has passed through the Finisher Gate and was directed to the Finisher.
The Exit Chute uses rolls and rubber paddles to move the paper into the Eject area. If the
paper is to be collected into sets and stapled, the Eject Rolls rotate in reverse and drive the
paper back into the Compiler Bin
the Bin, the Tamper aligns the edges of the paper sheets to form a neat paper set. The Stapler
then drives a staple through the set. As the Eject Rolls drive the paper set out of the Stapler,
they offset each paper set slightly from the previous set as they are delivered into the Stacker
Tray.
1/05
10-162
manuals4you.com manuals4you.com
(Figure 1). When the correct number of sheets has entered
DocuColor 12/DCCS50
Reissue