Xerox DocuColor 12/DCCS50 Service Manual page 1415

2
Install the IOT Rear Cover and the
EPC Mounting Plate at the same
time. Use the same screws (4)
Figure 8 Installing the Mounting Plate
9. For DCCS50:
• Reinstall the IDFE (REP 19.1).
For DC 12:
• Continue with this installation at step 10.
10. Mark off Tag 38 on the IOT Tag Matrix.
11. If the EPC Kit is being installed at the same time as the enablement kit: Go to the
EPC Assembly Installation instructions in the EPC Kit installation instructions and com-
plete the installation.
If the EPC Kit is not being installed at this time: Continue with these instructions.
12. Dock the Finisher.
13. For DC 12 with attached Splash DFE:
• Reconnect the DocuColor 12 interface Cables (left side print and right side scan) to
the IOT.
• Switch On the Server power.
For DC 12 with attached Fiery DFE:
• Reconnect the Copier Interface Cables (left side print and right side scan) to the
interface ports on the copier.
• Switch On the Server power.
14. Reconnect the machine power cord; switch On the power.
Reissue
DocuColor 12/DCCS50
1
Line up the 4
holes
1/05
9-41
Installation Instructions