Xerox DocuColor 12/DCCS50 Service Manual page 1414

2
Install Connector
Bracket at same
location as the old
bracket, using
existing screw
Figure 6 Installing the new Connector Bracket
5. Install the Locking Clamp (Figure 7).
Installation Instructions
1
Insert P899 and
P657 (new)-
from rear
1
Install the
Clamp
6. Reinstall the Tray Module Rear Cover
Use caution when aligning the Mounting Plate with the IOT Rear Cover. It may be extremely
difficult to separate the Mounting Plate from the IOT Rear Cover, after they have been pressed
together.
7. Place the IOT Rear Cover face up on a flat surface. Remove the protective backing from
the five adhesive strips of tape located on the back of the Mounting Plate. Align the
Mounting Plate over the IOT Rear Cover, align the 4 holes, and Press down to fasten
(adhere) the Mounting Plate to the IOT Rear Cover. (see
8. Install the EPC Mounting Plate and the IOT Rear Cover
1/05
9-40
manuals4you.com manuals4you.com
2
Gather the harness
and lock the clamp
Figure 7 Installing the Locking Clamp
(PL 11.3).
CAUTION
Figure
(Figure
8)
8):
Reissue
DocuColor 12/DCCS50