Table of Contents
Advertisement
Timing Comments Assertion/NegationÑThe same as the data bus.
7.2.7.2.2 Data Bus Parity (DP[0Ð7])ÑInput
Following are the state meaning and timing comments for the DP input signals.
State Meaning
Timing Comments Assertion/NegationÑThe same as D[0Ð63].
7.2.8 Data Transfer Termination Signals
Data termination signals are required after each data beat in a data transfer. Note that in a
single-beat transaction that is not a port-size transfer, the data termination signals also
indicate the end of the tenure. In burst or port size accesses, the data termination signals
apply to individual beats and indicate the end of the tenure only after the Þnal data beat. For
a detailed description of how these signals interact, see Section 8.5, ÒData Tenure
Operations.Ó
7.2.8.1 Transfer Acknowledge (TA)
The transfer acknowledge (TA) signal is both input and output on the MPC8260.
7.2.8.1.1 Transfer Acknowledge (TA)ÑInput
Following are the state meaning and timing comments for the TA input signal.
State Meaning
MOTOROLA
Table 7-1. DP[0Ð7] Signal Assignments
Signal Name
Data Bus Signal Assignments
DP0
DP1
DP2
DP3
DP4
DP5
DP6
DP7
High ImpedanceÑThe same as the data bus.
Asserted/NegatedÑRepresents odd parity for each byte of read data.
Parity is checked on all data byte lanes, regardless of the size of the
transfer. Detected even parity causes a checkstop if data parity errors
are enabled in the BCS[PAR_EN].
AssertedÑIndicates that a single-beat data transfer completed
successfully or that a data beat in a burst transfer completed
successfully. Note that TA must be asserted for each data beat in a
burst transaction. For more information, see Section 8.5.3, ÒData
Bus Transfers and Normal Termination.Ó
Chapter 7. 60x Signals
Part III. The Hardware Interface
D[0Ð7]
D[8Ð15
D[16Ð23]
D[24Ð31]
D[32Ð39]
D[40Ð47]
D[48Ð55]
D[56Ð63]
7-15
Advertisement
Table of Contents
