Motorola MPC8260 PowerQUICC II User Manual page 298

Part III. The Hardware Interface
Table 10-7. PSDMR Field Descriptions (Continued)
Bits Name
8Ð10 BSMA Bank select multiplexed address line. Selects the address pins to serve as bank-select address
for the 60x SDRAM. The bank select address can also be output on the BANKSEL pins
(optional). See Section 10.4.5.1, ÒSDRAM Address Multiplexing (SDAM and BSMA).Ó
000 A12ÐA14
001 A13ÐA15
010 A14ÐA16
011 A15ÐA17
100 A16ÐA18
101 A17ÐA19
110 A18ÐA20
111 A19ÐA21
11Ð13 SDA10 ÒA10Ó control. With ORx[PBI], determines which address line can be output to SDA10 during an
ACTIVATE
Section 10.4.12.1, ÒSDRAM ConÞguration Example (Page-Based Interleaving).Ó
For PBI = 0:
000 A12
001 A11
010 A10
011 A9
100 A8
101 A7
110 A6
111 A5
14Ð16 RFRC Refresh recovery. DeÞnes the earliest timing for an activate command after a
command. Sets the refresh recovery interval in clock cycles. See Section 10.4.6.6, ÒRefresh
Recovery Interval (RFRC),Ó for how to set this Þeld.
000 Reserved
001 3 clocks
010 4 clocks
011 5 clocks
100 6 clocks
101 7 clocks
110 8 clocks
111 16 clocks
17Ð19 PRETOACT Precharge to activate interval. DeÞnes the earliest timing for
after a precharge command. See Section 10.4.6.1, ÒPrecharge-to-Activate Interval.Ó
001 1 clock-cycle wait states
010 2 clock-cycle wait states
...
111 7 clock-cycle wait states
000 8 clock-cycle wait states
20Ð22 ACTTORW Activate to read/write interval. DeÞnes the earliest timing for
ACTIVATE
001 1 clock cycle
010 2 clock cycles
...
111 7 clock cycles
000 8 clock cycles
10-22
command, when SDRAM is selected, to control the memory access. See
For PBI = 1:
000 A10
001 A9
010 A8
011 A7
100 A6
101 A5
110 A4
111 A3
SDRAM DeviceÐSpeciÞc Parameters:
command. See Section 10.4.6.2, ÒActivate to Read/Write Interval.Ó
MPC8260 PowerQUICC II UserÕs Manual
Description
ACTIVATE
/
READ WRITE
REFRESH
or command
REFRESH
command after an
MOTOROLA