Scc Uart Parameter Ram - Motorola MPC8260 PowerQUICC II User Manual

Part IV. Communications Processor Module
receive shift register are transferred to the receive FIFO before proceeding to the receive
buffer. The CPM ßags UART events, including reception errors, in SCCE and the RxBD
status and control Þelds. GSMR_H[RFW] must be set for an 8-bit receive FIFO.
The synchronous UART transmit shift register sends outgoing data on TXDx. Data is then
clocked synchronously with the transmit clock, which can have an internal or external
source.

20.4 SCC UART Parameter RAM

For UART mode, the protocol-speciÞc area of the SCC parameter RAM is mapped as in
Table 20-1.
Table 20-1. UART-Specific SCC Parameter RAM Memory Map
1
Offset Name
0x30 Ñ
0x38 MAX_IDL
0x3A IDLC
0x3C BRKCR
0x3E PAREC
0x40 FRMEC
0x42 NOSEC
0x44 BRKEC
0x46 BRKLN
0x48 UADDR1
0x4A UADDR2
0x4C RTEMP
20-4
Width
DWord Reserved
Hword Maximum idle characters. When a character is received, the receiver begins
counting idle characters. If MAX_IDL idle characters are received before the next
data character, an idle timeout occurs and the buffer is closed, generating a
maskable interrupt request to the core to receive the data from the buffer. Thus,
MAX_IDL offers a way to demarcate frames. To disable the feature, clear
MAX_IDL. The bit length of an idle character is calculated as follows: 1 + data
length (5Ð9) + 1 (if parity is used) + number of stop bits (1Ð2). For 8 data bits, no
parity, and 1 stop bit, the character length is 10 bits.
Hword Temporary idle counter. Holds the current idle count for the idle timeout process.
IDLC is a down-counter and does not need to be initialized or accessed.
Hword Break count register (transmit). Determines the number of break characters the
transmitter sends. The transmitter sends a break character sequence when a
command is issued. For 8 data bits, no parity, 1 stop bit, and 1 start bit,
TRANSMIT
each break character consists of 10 zero bits.
Hword User-initialized,16-bit (moduloÐ2
PAREC counts received parity errors.
Hword
FRMEC counts received characters with framing errors.
NOSEC counts received characters with noise errors.
Hword
BRKEC counts break conditions on the signal. A break condition can last for
hundreds of bit times, yet BRKEC is incremented only once during that period.
Hword
Hword Last received break length. Holds the length of the last received break character
sequence measured in character units. For example, if RXDx is low for 20 bit times
and the deÞned character length is 10 bits, BRKLN = 0x002, indicating that the
break sequence is at least 2 characters long. BRKLN is accurate to within one
character length.
Hword UART address character 1/2. In multidrop mode, the receiver provides automatic
address recognition for two addresses. In this case, program the lower order bytes
Hword
of UADDR1 and UADDR2 with the two preferred addresses.
Hword Temp storage
MPC8260 PowerQUICC II UserÕs Manual
Description
16
) counters incremented by the CP.
STOP
MOTOROLA