Parameter Verification - Mitsubishi Electric FR-F800 Instruction Manual

5.15.2

Parameter verification

• Whether the parameter settings of inverters are the same or not can be checked.
1.
Copy the parameter settings of the verification source inverter to operation panel according to the procedure on
2.
Move the operation panel to the inverter to be verified.
Screen at power-ON
3.
The monitor display appears.
Parameter setting mode
4.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
5.
Turn to
" " appears.
Parameter verification
Turn to change to setting value "
Press . Verification of the parameter settings copied to the operation panel and the parameter settings of the verification
6.
destination inverter is started. (It takes about 60 seconds to verify all the settings. During verification, "
If there are different parameters, the different parameter number and "
To continue verification, press
7.
" " and "
NOTE
• flickers... Why?
- The set frequency may be incorrect. To continue verification, press
Copying and verifying parameters on the operation panel
Operation
(parameter copy) and press
" (parameter copy verification mode).
.
" flicker alternately after verification ends.
.
" flicker.
.
page 521.
" flickers.)
523
PARAMETERS
5