Mitsubishi Electric FR-F800 Instruction Manual page 276

Types of monitor
BACnet terminal FM/CA
0.1%
output level
BACnet terminal AM
0.1%
output level
Remote output value 1 0.1%
Remote output value 2 0.1%
Remote output value 3 0.1%
Remote output value 4 0.1%
PID manipulated variable 0.1%
Second PID set point 0.1%
Second PID measured
0.1%
value
Second PID deviation 0.1%
Second PID measured
0.1%
value 2
Second PID manipulated
0.1%
variable
Control circuit temperature 1°C

Differs according to capacities. (FR-F820-02330(55K) or lower, FR-F840-01160(55K) or lower /FR-F820-03160(75K) or higher, FR-F840-
01800(75K) or higher)

When the output current is less than the specified current level (5% of the rated inverter current), the output current is monitored as 0 A.
Therefore, the monitored value of an output current and output power may be displayed as "0" when using a much smaller-capacity motor
compared to the inverter or in other instances that cause the output current to fall below the specified value.

The setting is available only with terminal AM (Pr.158).

The setting is available only with terminal FM/CA (Pr.54).
Pr.54 (FM/CA)
Unit Pr.158 (AM)
setting
85

86

87
88
89
90
91

92
93
94

95
96

98
(M) Monitor display and monitor output signal
Terminal FM, CA, AM Negative
Full-scale value (-) output
100%
100% 
1000% 
1000%
1000%
1000%
100% 
100%
100%
200% 
100%
100% 
100°C 
REMARKS
The value set in the Analog
Output object (ID=0: Terminal
FM/CA) for BACnet
communication is output.
The value set in the Analog
Output object (ID=1: Terminal
AM) for BACnet
communication is output.
(The output is always
negative regardless of the
Pr.290 setting when the
monitored value is negative.)
Refer to page 300 for the
analog remote output.
Output with a minus sign
(terminal AM)
Refer to page 389 for the PID
control.
Terminal FM/CA: 0 to 100°C
terminal AM: -20 to 100°C
275
PARAMETERS
5
GROUP
M