Usb Connector; Usb Host Communication - Mitsubishi Electric FR-F800 Instruction Manual

2.7.2

USB connector

Place a flathead screwdriver,
etc. in a slot and push up the
cover to open.
USB host communication
Interface
Transmission speed
Wiring length
Connector
Format
Compatible
Capacity
USB memory
Encryption function
• Different inverter data can be saved in a USB memory device.
The USB host communication enables the following functions.
Function
• Copies the parameter setting from the inverter to the USB memory device. A maximum of 99 parameter
setting files can be saved in a USB memory device.
• The parameter setting data copied in the USB memory device can be copied to other inverters. This
Parameter copy function is useful in backing up the parameter setting or for sharing the parameter setting among multiple
inverters.
• The parameter setting file can be copied onto a personal computer from the USB memory device and
edited using FR Configurator2.
• The monitored data and output status of the signals can be saved in a USB memory device.
Trace
• The saved data can be imported to FR Configurator2 to diagnose the operating status of the inverter.
• This function copies the PLC function project data to a USB memory device when the PLC function is
used.
PLC function data
• The PLC function project data copied in the USB memory device can be copied to other inverters.
copy
• This function is useful in backing up the parameter setting and for allowing multiple inverters to operate
by the same sequence programs.
• When the inverter recognizes the USB memory device without any problem,
operation panel.
• When the USB memory device is removed,
• The operating status of the USB host can be checked on the LED display of the inverter.
LED display status
OFF No USB connection.
ON The communication is established between the inverter and the USB device.
Flickering rapidly The USB memory device is being accessed. (Do not remove the USB memory device.)
Flickering slowly Error in the USB connection.
• When a device such as a USB battery charger is connected to the USB connector and an excessive current (500 mA or
more) flows, USB host error
• When the UF warning appears, the USB error can be canceled by removing the USB device and setting Pr.1049 = "1". (The
UF warning can also be canceled by resetting the inverter power or resetting with the RES signal.)
NOTE
• Do not connect devices other than a USB memory device to the inverter.
• If a USB device is connected to the inverter via a USB hub, the inverter cannot recognize the USB memory device properly.
Conforms to USB1.1
12 Mbps
Maximum 5 m
USB A connector (receptacle)
FAT32
1 GB or more (used in the recorder mode of the trace function)
Not available
Description
is briefly displayed on the operation panel.
Operating status
(UF warning) is displayed on the operation panel.
Communication connectors and terminals
USB host
(A connector)
USB
Communication status
indicator (LED)
USB device
(Mini B connector)
Personal computer
(FR Configurator2)
is briefly displayed on the
INSTALLATION AND WIRING
Refer
to page
524
433
2
431
61