Using The Setting Dial Like A Potentiometer To Perform Operation - Mitsubishi Electric FR-F800 Instruction Manual

Basic operation procedure (PU operation)
NOTE
• To display the set frequency under PU operation mode or External/PU combined operation mode 1 (Pr.79 = "3"), press
(Refer to page
• can also be used like a potentiometer to perform operation. (Refer to
Parameters referred to
Pr.7 Acceleration time, Pr.8 Deceleration time
Pr.79 Operation mode selection
4.5.2
Using the setting dial like a potentiometer to
perform operation
POINT POINT
• Set Pr.161 Frequency setting/key lock operation selection ="1" (setting dial potentiometer).
Operation example
Screen at power-ON
1.
The monitor display appears.
Changing the operation mode
2.
Press to choose the PU operation mode. [PU] indicator is on.
Changing the parameter setting
3.
Change Pr.161 setting to "1". (For setting value change, refer to
Start
4.
Press or
Setting the frequency
Turn " " until "
5.
needs not to be pressed.
NOTE
• If the display changes from flickering "60.00" to "0.00", Pr.161 Frequency setting/key lock operation selection may be set
to a value other than "1".
• Simply turning
• The newly-set frequency will be saved as the set frequency in EEPROM after 10 s.
• With the setting dial, the frequency can go up to the setting value of Pr.1 Maximum frequency.
Check the Pr.1 Maximum frequency setting, and adjust the setting according to the application.
Parameters referred to
Pr.1 Maximum frequency
Pr.161 Frequency setting/key lock operation selection
98
BASIC OPERATION
263.)
page 187
page 200
Change the frequency from 0 Hz to 60 Hz during operation
to start the inverter operation.
" appears. The set frequency flickers. (The frequency flickers for about 5 s.)
will enable frequency setting whether the inverter is running or at a stop.
page 245
page 166
page
Operation
page 91.)
98.)
.