Mitsubishi Electric FR-F800 Instruction Manual page 269

(M) Monitor display and monitor output signal

When using the item as the main monitor data on the LCD operation panel (FR-LU08) or the parameter unit (FR-PU07), use Pr.774 to Pr.776 or
the monitor function of the FR-LU08 or the FR-PU07 for setting.

The cumulative energization time and actual operation time are accumulated from 0 to 65535 hours, then cleared, and accumulated again from
0.

The actual operation time does not increase if the cumulative running time before power OFF is less than an hour.

When using the parameter unit (FR-PU07), "kW" is displayed.

Differs according to capacities. (FR-F820-02330(55K) or lower, FR-F840-01160(55K) or lower /FR-F820-03160(75K) or higher, FR-F840-
01800(75K) or higher)

Since the voltage and current display on the operation panel (FR-DU08) is shown in four digits, a monitor value of more than "9999" is displayed
as "----".

The setting is available only for standard models.

When the output current is less than the specified current level (5% of the rated inverter current), the output current is monitored as 0 A.
Therefore, the monitored value of an output current and output power may be displayed as "0" when using a much smaller-capacity motor
compared to the inverter or in other instances that cause the output current to fall below the specified value.

Available when the plug-in option is connected.
 Input terminal monitor details ("1" denotes terminal ON, "0" denotes terminal OFF, and "―" denotes undetermined value.)
b15
― ― ―
 Output terminal monitor details ("1" denotes terminal ON, "0" denotes terminal OFF, and "―" denotes undetermined value.)
b15
― ― ―
 Option input terminal monitor 1 details (FR-A8AX input terminal status, "1" denotes terminal ON and "0" denotes terminal OFF.) ―― All are OFF
when the option is not connected.
b15
X15 X14 X13 X12
 Option input terminal monitor 2 details (FR-A8AX input terminal status. "1" denotes terminal ON, "0" denotes terminal OFF, "―" denotes
undetermined value.) ―― All are OFF when the option is not connected.
b15
― ― ―
 Option output terminal monitor details (FR-A8AY/A8AR output terminal status. "1" denotes terminal ON, "0" denotes terminal OFF, and "―" denotes
undetermined value.)―― All are OFF when the option is not connected.
b15
― ― ―
 The increment is 1 when Pr.37 = "1 to 9998" or when Pr.144 = "2 to 12" or "102 to 112". (Refer to
 The monitored values are retained even if an inverter fault occurs. Resetting will clear the retained values.
 Parameter setting is not available for setting the item as the main monitor data on the LCD operation panel (FR-LU08) or the parameter unit (FR-
PU07). Use the monitor function of the FR-LU08 or the FR-PU07 for setting.
268
PARAMETERS
STP
― CS RES
(STOP)
― ― ― ―
X11 X10 X9
― ― ― ―
― ― ― RA3
MRS JOG RH RM
― SO ABC2 ABC1
X8 X7 X6 X5
― ― ― ―
RA2 RA1 Y6 Y5
RL RT AU STR
FU OL IPF SU
X4 X3 X2 X1
― ― ― ―
Y4 Y3 Y2 Y1
page 261.)
b0
STF
b0
RUN
b0
X0
b0
DY
b0
Y0