Copying The Plc Function Project Data To Usb Memory - Mitsubishi Electric FR-F800 Instruction Manual

(A) Application parameters
Copying the PLC function project data to USB memory
• This function copies the PLC function project data to a USB memory device.
The PLC function project data copied in the USB memory device can be copied to other inverters.
This function is useful in backing up the parameter setting and for allowing multiple inverters to operate by the same
sequence programs.
• Refer to page 61 for an outline of the USB communication function.
Monitor mode
USB memory mode
Project data file
number (displays 1
to 99, unrelated to
the number of files
saved in the USB
memory device)
• The following data can be copied by copying the project data via USB memory.
Extension
.QPA Parameter file
.QPG Program file
.C32 Function block source information
.QCD Global text comment information
.DAT Project management information
.TXT Copy information
NOTE
• If the project data of the PLC function is locked with a password using FR Configurator 2, copying to the USB memory device
and verification are disabled. Also if set to write-disabled, writing to the inverter is disabled.For the details of the PLC function,
refer to the PLC Function Programming Manual and the Instruction Manual of FR Configurator 2.
Parameters referred to
Pr.338 Communication operation command source
432
PARAMETERS
Parameter setting mode
Copy from inverter to
File type
Supported
Supported
Supported
Supported
Supported
Supported
page 210
Function mode Faults history mode
Overwrite the inverter project data file onto the
designated file in the USB memory device.
Write the designated project data file of the USB
memory device onto a data file of the inverter.
Verify the designated project data file of the USB
memory device against the project data file of the
inverter.
USB memory
Supported
Supported
Supported
Supported
Not available
Not available
Copy from USB memory
to inverter