Check and clear of the faults history
Faults history clearing procedure
POINT
POINT
Fault history clear
• Set Err.CL
Screen at power-ON
1.
The monitor display appears.
Parameter setting mode
2.
Press
to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
3.
Turn
until
appears.
Faults history clear
Turn
to change the set value to "
"
" and "
4.
532
PROTECTIVE FUNCTIONS
= "1" to clear the faults history.
(faults history clear) appears. Press
". Press
" flicker alternately after parameters are cleared.
Turn
to read another parameter.
Press
to show the setting again.
Press
twice to show the next parameter.
Operation
to read the present set value. "
to start clear.
" (initial value)