Parameter Verification - Mitsubishi Electric FR-F820-00046 Instruction Manual

Fr-f800 series
Hide thumbs Also See for FR-F820-00046:
Table of Contents

Advertisement

5.15.2 Parameter verification

• Whether the parameter settings of inverters are the same or not can be checked.
Operating procedure
1.
Copy the parameter settings of the verification source inverter to the operation panel according to the procedure on
page
552.
2.
Detach the operation panel from the source inverter and attach it to the verification target inverter.
3.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
4.
Selecting the parameter setting mode
Press
5.
Selecting the parameter
Turn
"
6.
Parameter verification
Turn
Press
verification destination inverter is started. (It takes about 60 seconds to verify all the settings. During verification,
"
● If there are different parameters, the different parameter number and "
● To continue verification, press
7.
"
NOTE
• When "
554
5. PARAMETERS
5.15 Copying and verifying parameters on the operation panel
to choose the parameter setting mode. (The parameter number read previously appears.)
to "
" (Parameter copy) and press
" appears.
to change to setting value "
. Verification of the parameter settings copied to the operation panel and the parameter settings of the
" blinks.)
" and "
" blinks, the set frequency may be incorrect. To continue verification, press
" (Parameter copy verification mode).
.
" are displayed alternately after verification ends.
.
" are displayed alternately.
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents