Parameter Copy And Parameter Verification; Parameter Copy - Mitsubishi Electric FR-A740-00023 Instruction Manual

Parameter copy and parameter verification

4.30 Parameter copy and parameter verification

PCPY Setting
0
1
2
3
REMARKS
· When the copy destination inverter is not the FR-A700 series or parameter copy write is performed after parameter copy read is
stopped, "model error (
· Refer to the parameter list on page 444 and later for availability of parameter copy.
· When the power is turned off or an operation panel is disconnected, etc. during parameter copy write, perform write again or
check the values by parameter verification.

4.30.1 Parameter copy

Parameter settings can be copied to multiple inverters.
1.
Connect the operation panel to the
copy source inverter.
• Connect it during a stop.
2.
Press
setting mode.
3.
Turn until
appears.
4.
Press to to read the currently set value.
" "(initial value) appears.
5.
Turn to change it to the setting value
" ".
6.
Press
to the operation panel.
7.
Connect the operation panel to the
copy source inverter.
8.
After performing steps 2 to 5,
turn to change it to "
9.
Press
the operation panel to the destination inverter.
10.
When copy is completed,
" " and "
11.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power off once, before starting operation.
386
Cancel
Copy the source parameters to the operation panel.
Write the parameters copied to the operation panel into the destination inverter.
Verify parameters in the inverter and operation panel. (Refer to page 47.)
)" is displayed.
Operation
to choose the parameter

(parameter copy)

to copy the source parameters
".
to write the parameters copied to
" flicker.
Description
About 30s later
Flicker ··· Parameter copy complete!!
Flicker ··· Parameter copy complete!!
Display
The parameter
number previously
read appears.
Flickers for about 30s
The frequency flickers
for about 30s