6-Point Frequency Jump (Pr.552) - Mitsubishi Electric FR-F800 Instruction Manual

6-point frequency jump (Pr.552)
• A total of six jump areas can be set by setting the common jump range for the frequencies set in Pr.31 to Pr.36.
• When frequency jump ranges overlap, the lower limit of the lower jump range and the upper limit of the upper jump range
are used.
• When the set frequency decreases and falls within the jump range, the upper limit of the jump range is the set frequency.
When the set frequency increases and falls within the jump range, the lower limit of the jump range is the set frequency.
Pr.36
Pr.35
Pr.33
Pr.34
Pr.32
Pr.31
0
NOTE
• During acceleration/deceleration, the running frequency within the set area is valid.
• If the setting ranges of individual groups (1A and 1B, 2A and 2B, 3A and 3B) overlap, write disable error (Er1) will occur.
• Setting Pr.552 = "0" disables frequency jumps.
• If a jump frequency that exceeds Pr.1(Pr.18) Maximum frequency is set for the 3-point jump, the maximum frequency
setting is the set frequency. If the set frequency is less than the jump frequency Pr.2 Minimum frequency, the jump
frequency is the set frequency. (The set frequency can be equal to or lower than the frequency lower limit.)
Example with 6-point frequency jump
Output frequency
Maximum
frequency
0 Set frequency
Maximum frequency and frequency jump
Parameters referred to ???????
Pr.1 Maximum frequency, Pr.18 High speed maximum frequency, Pr.2 Minimum frequency
Jump range
Pr.552
Jump range
Pr.552
Input set frequency
Output frequency
Pr.552
Minimum
frequency
Pr.552
0
Minimum frequency and frequency jump
(H) Protective function parameter
Set frequency after
frequency jump
Pr.32
Pr.31
0
Input set frequency
Pr.552
Pr.552
Set frequency
page 245
Pr.552 Jump range
Pr.552
247
PARAMETERS
5
GROUP
H