Show Policy-Map - Cisco 300 Series Cli Manual

49
802
•
access-group
Control List (ACL).
Default Configuration
No class map is defined for the policy map.
Command Mode
Policy-map Configuration mode
User Guidelines
This is the same as creating a class map and then binding it to the policy map.
You can specify an existing class map in this command, or you can use the
access-group parameter to create a new class map.
After the policy-map is defined, use the
port/port-channel.
Example
The following example defines a traffic classification (class map) called class1
containing an ACL called enterprise. The class is in a policy map called policy1.
The policy-map policy1 now contains the ACL enterprise.
switchxxxxxx(config)#
switchxxxxxx(config-pmap)#
49.9

show policy-map

Use the show policy-map EXEC mode command to display all policy maps or a
specific policy map.
This command is only available when QoS is in advanced mode.
Syntax
show policy-map [ policy-map-name
Parameters
policy-map-name—Specifies the policy map name.
acl-name
—Specifies the name of an IP or MAC Access
service-policy
policy1
policy-map
class class1
]
78-21075-01 Command Line Interface Reference Guide
Quality of Service (QoS) Commands
command to attach it to a
access-group enterprise