Power Inline Limit-Mode; Show Power Inline - Cisco 300 Series Cli Manual

25
380
Example
The following example sets inline power on a port.
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# power inline limit 2222
25.7

power inline limit-mode

Use the power inline limit-mode Global Configuration mode command to set the
power limit mode of the system. Use the no form of this command to return to
default.
Syntax
power inline limit-mode
no power inline limit-mode
Parameters
•
class—The power limit of a port is based on the class of the PD (Power
Device) as detected during the classification process
•
port—The power limit of a port is fixed regardless of the class of the
discovered PD.
Command Mode
Global Configuration mode
Example
The following example sets the power limit to class.
switchxxxxxx(config)# power inline limit-mode class
25.8

show power inline

Use the show power inline EXEC mode command to display information about the
inline power for all interfaces or for a specific interface.
{class | port}
78-21075-01 Command Line Interface Reference Guide
Power over Ethernet (PoE) Commands