Clear Arp-Cache - Cisco 300 Series Cli Manual

43
IP Addressing Commands
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
ARP Proxy is enabled.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. It cannot be
configured for a range of interfaces (range context).
User Guidelines
This configuration can be applied only if at least one IP address is defined on a
specific interface.To use this command, you must put the switch into routing mode
using set system.
Example
The following example enables ARP proxy when the switch is in router mode.
switchxxxxxx(config-if)# ip proxy-arp

43 10 clear arp-cache

Use the clear arp-cache Privileged EXEC mode command to delete all dynamic
entries from the ARP cache.
Syntax
clear arp-cache
Command Mode
Privileged EXEC mode
Example
The following example deletes all dynamic entries from the ARP cache.
switchxxxxxx#
clear arp-cache
716 78-21075-01 Command Line Interface Reference Guide