Power Inline Priority - Cisco 300 Series Cli Manual

Power over Ethernet (PoE) Commands
78-21075-01 Command Line Interface Reference Guide
Example
The following example adds the description 'ip phone' of the device connected to
port 4.
switchxxxxxx(config)# interface
switchxxxxxx(config-if)# power inline powered-device ip_phone
25.3

power inline priority

Use the power inline priority Interface Configuration (Ethernet) mode command to
configure the interface inline power management priority. Use the no form of this
command to restore the default configuration.
Syntax
power inline priority
no power inline priority
Parameters
•
critical—Specifies that the powered device operation is critical.
•
high—Specifies that the powered device operation is high priority.
•
low—Specifies that the powered device operation is low priority.
Default Configuration
The default configuration is set to low priority.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets the inline power management priority of
gigabitethernet port 4 to High.
switchxxxxxx(config)# interface
switchxxxxxx(config-if)# power inline priority high
gi4
{critical | high | low}
gi4
25
377