Cisco 300 Series Cli Manual page 382

25
382
Example
The following example displays information about the inline power for a specific
port.
switchxxxxxx(config)# show power inline gi1
Power limit: 15 W
Power limit (for port based power-limit mode): 15 W
Port Powered Device
----- --------------
gi1 IP Phone Model A
The following table describes the fields shown in the display:
Field Description
Power Inline power sourcing equipment operational
status.
Nominal Power Inline power sourcing equipment nominal
power in Watts.
Consumed Measured usage power in Watts.
Power
Usage Threshold Usage threshold expressed in percent for
comparing the measured power and initiating
an alarm if threshold is exceeded.
Traps Indicates if inline power traps are enabled.
Port Ethernet port number.
Powered device Description of the powered device type.
State Indicates if the port is enabled to provide
power. The possible values are Auto or Never.
Priority Port inline power management priority. The
possible values are Critical, High or Low.
Status Power operational state. The possible values
are On, Off, Test-Fail, Testing, Searching or Fault.
Class Power consumption classification of the
powered device.
Overload Counts the number of overload conditions
Counter detected.
Power over Ethernet (PoE) Commands
State Status
----------- --------
Auto On
78-21075-01 Command Line Interface Reference Guide
Priority Class
-------- -------
High Class0