Spanning-Tree Commands; Spanning-Tree; Spanning-Tree Mode - Cisco 300 Series Cli Manual

Spanning-Tree Commands

78-21075-01 Command Line Interface Reference Guide
31.1

spanning-tree

Use the spanning-tree Global Configuration mode command to enable
spanning-tree functionality. Use the no form of this command to disable the
spanning-tree functionality.
Syntax
spanning-tree
no spanning-tree
Parameters
N/A
Default Configuration
Spanning-tree is enabled.
Command Mode
Global Configuration mode
Example
The following example enables spanning-tree functionality.
switchxxxxxx(config)#
31.2

spanning-tree mode

Use the spanning-tree mode Global Configuration mode command to select
which Spanning Tree Protocol (STP) protocol to run. Use the no form of this
command to restore the default configuration.
Syntax
spanning-tree mode
spanning-tree
{stp | rstp | mst}
31
451