Ip Source-Guard Tcam Retries-Freq - Cisco 300 Series Cli Manual

42
692
User Guidelines
The device currently supports filtering that is based only on the source IP address.
In future, the device might supports filtering mode that is based on the MAC
address and IP source address. Currently the MAC address field is an informative
field.
Example
The following example configures the static IP source bindings.
switchxxxxxx(config)#
5
gi

42.14 ip source-guard tcam retries-freq

Use the ip source-guard tcam retries-freq Global Configuration mode command to
set the frequency of retries for TCAM resources for inactive IP Source Guard
addresses. Use the no form of this command to restore the default configuration.
Syntax
ip source-guard tcam retries-freq {
no ip source-guard tcam retries-freq
Parameters
•
seconds—Specifies the retries frequency in seconds. (Range: 10–600)
•
never—Disables automatic searching for TCAM resources.
Default Configuration
The default retries frequency is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
Since the IP Source Guard uses the Ternary Content Addressable Memory
(TCAM) resources, there may be situations when IP Source Guard addresses are
inactive because of a lack of TCAM resources.
DHCP Snooping and ARP Inspection Commands
ip source-guard binding
seconds | never}
78-21075-01 Command Line Interface Reference Guide
0060.704C.73FF 23 176.10.1.1